Promotional Offers are available on the Lacanche range, please phone for details.
The Lacanche range cooker: Macon Classic is one of our best selling range cooker. The two large 55-litre ovens can be configured for gas and electric or all electric. The third full oven and grill (taking the same size oven trays and racks as the main ovens) offers even greater performance and flexibility. There is a choice of two gas hobs or 5-zone induction hob. This is a workhorse of Lacanche range cookers capable of prodigious output when needed, but with a fast-heating, small oven with grill when something smaller is required.
The Macon range cookers can be ordered for natural or LPG (bottled) gas or all electric.
Features of the Macon range cookers from the Lacanche range:
Dimensions (mm): Width 1000mm x Height 900mm x Depth 650mm
A choice of 3 hobs
1 x 20 litre oven
2 x 55 litre ovens
1 x drawer
About the Lacanche range cookers:
A foundry was established in the French village of Lacanche, deep in the Burgundian countryside over 200 years ago and range cookers have been manufactured there by hand ever since -both for the commercial and domestic markets. Apart from this extraordinary heritage, what makes Lacanche range cookers so different from other range cookers on the market is that they are still made to exacting standards entirely by hand and to order.
Advantages of the Lacanche range cooker:
Hand made to order
Three year warranty
Highest possible build quality
Gas or electric ovens and hobs
27 different enamel colour finishes
Solid brass burner tops for greater flame efficiency
Once piece stainless hob with easy clean edges and generous spillage area
2 piece burners for ease of cleaning
Powerful induction hob can bring 1 litre of water to boiling point in 2.5 minutes
Heavy duty cast iron pan supports for maximum stability
Oven intrerior coated with eight layers of tough enamel
Additional safety thermostat on electrical/convection oven
Choice of natural gas or LPG models
Certain items are shown for display purposes only - please ask for details.
INSTALLATION AND COMMISSIONING
Installation and Commissioning should be in accordance with the manufacturer's Installer's Manual and also current Gas Safe and IEE regulations. In order that installation and commissioning is carried out correctly you should use a suitable qualified and Gas Safe registered engineer. Your local Lacanche stockists can advise. The appropriate installation guidance for your cooker will be sent with the order acknowledgement.
Note: COMMISSIONING IS CRUCIAL for the correct operation of your Lacanche. Failure to have your Lacanche commissioned correctly will result in over/under performance of burners and ovens and inconsistent temperatures.
POWER SUPPLY / SERVICES
After ordering your Lacanche range cooker information will be sent to you detailing what services you will require to power the cooker.
Electric feeds will be standard single phase 230 volt supply. On some larger models including many electric features, two such supplies may be required and this will be notified in the information sent to you after placing your order. On request, Lacanche range cookers can be built for three phase electricity.
Information on the gas power/requirement of your cooker will be provided after your order has been placed. We offer the appropriate flexihose for the type of gas (LPG or Natural Gas), which is designed to plug into a female half inch / 15mm bayonet fitting on site (location to be advised in post order confirmation).
When the appliance is being built in to a run of units, a gap of 50mm must be allowed both sides of the cooker unless the sides of the units adjacent to the cooker are covered with adequate thermal insulation. Otherwise the units must not butt up to the sides of the cooker. An infill strip can be used to conceal the gap, and flat worktops/cabinet surfaces can run up to the edge of the hob.
Lacanche range cookers are designed to sit proud of adjacent units. Units and infill strips adjacent to the cooker should not sit flush or proud of the cooker doors (including oven, simmer oven and cupboard doors), but should sit flush with the main boy of the cooker.
The stainless steel hob of the appliance should not be lower than adjoining worktops. These worktops can butt up to the hob.
For cookers situated in confined spaces (e.g. inglenooks), with gas ovens, or with tiles rather than a backsplash on the back wall behind and above the cooker, we recommend installing a backstrip - see backstrips in Accessories. Alternatively a gap of 70mm should be left between the cooker and the wall to the rear. An infill strip (worktop) can be used to conceal the 70mm gap.
Wall units that are placed to the left and right of the cooker must be at a minimum distance of 450mm above the hob tops on both sides. All cookers over 1 metre wide are designed to be mounted against a wall and are not intended as free standing island cookers.
Any combustible materials must be a minimum of 850mm from the top of the cooker. Please note that it is advisable to have a wipe clean surface on the wall above the cooker, such as our stainless steel backsplashes.
All Lacanche cookers are built with a plinth incorporated into the base of the cooker. The plinth allows for greater manoeuvrability when putting the cooker in its final position and also allows for the cooker to be levelled. The height is adjustable (900mm to 910mm). A tool for making adjustments is supplied. The plinths have a brushed stainless steel kick pate on the front. The cookers also have adjustable front feet.
The above information is not exhaustive and we recommend that you check the relevant Installer's Manual.
For further details and to purchase this item, please get in touch or visit our showroom.Make an Enquiry